T

tadpole rider

Active Member
...the calibration test. The servos show up in the network. They get through the Servo Calibration. But, in the Test where the stick should be pulled full back and full right, it only comes full back. I have the A/P Knobs and the A/P Panel and installed the expert mode for the A/P. I double-checked the wiring at the servo and both sides of the plugs match with the wiring diagram.
Any hints as for my trouble-shooting path?
Thanks
 
tadpole rider said:
...the calibration test. The servos show up in the network. They get through the Servo Calibration. But, in the Test where the stick should be pulled full back and full right, it only comes full back. I have the A/P Knobs and the A/P Panel and installed the expert mode for the A/P. I double-checked the wiring at the servo and both sides of the plugs match with the wiring diagram.
Any hints as for my trouble-shooting path?
Thanks
Click to expand...
As I recall, during the test, the stick does not move full right BUT moves a bit to the right from center. Watch it carefully.
 
You must log in or register to reply here.