[JohnF]

I am looking at 34-10, step #2. It says, in part, "Final-Drill the two open holes in the roll bar." But I do not find any open holes in the roll bar. The predrilled holes in C1205 Latch Plate don't match anything...the already installed rivets, even if removed, would not provide anything that would align with this 'plastic' latch plate.

 

[JBPILOT]

Hey John

Go back and look at 24-2. The triangles shown were NOT supposed to be riveted. Those are the holes that you need to work with at the point you are.

John Bender

 

[JohnF]

c1205

Thanks, John