I'm starting to feel like I'm posting to many threads here but I checked the archives for this answer and couldn't come up with anything. So bare with me. I looked at the plans for the depth that you turn the rod end bearings in. On the vertical stab it says 1 1/16 from center hole to spar. Well if I do that the rod is only 3 full turns in. That can't be right. If that really is the measurement do you have to buy longer rod bearings? Also on the elevators, they say 7/8 max out. Can you turn them in far enough so they work and still get the right travel? I read in the archives that you should have atleast a couple threads past the nutplate. These are way to short if thats the case. What did everyone else do with these?