rapid_ascent
Well Known Member
I think I have the wrong rod end bearings installed on my F-665 pushrod. The drawing calls out M3414 but the parts I have installed are marked CM-4. Does anyone know what the width of the bearing should be? I have about an 1/8" gap even when I install the 2 washers when trying to mount the pushrod to the stick.
I've sent a request to Vans, but I'm trying to move on with my life and this is holding it up. Yes its a sickness.
I've sent a request to Vans, but I'm trying to move on with my life and this is holding it up. Yes its a sickness.