I'm having a bit of trouble tightening the rod end bearings for the aileron push/pull tubes.
My question is, How did you tighten the jam nuts? Proper torque values for this part can be found on page 5-18 of the RV-14 manual and are posted below. If I hold the rod end bearing itself with a wrench, the tube rotates when I apply torque to the jam nut.
How did you keep the tube stationary? By the way, this is an AN6 bolt.
My question is, How did you tighten the jam nuts? Proper torque values for this part can be found on page 5-18 of the RV-14 manual and are posted below. If I hold the rod end bearing itself with a wrench, the tube rotates when I apply torque to the jam nut.
How did you keep the tube stationary? By the way, this is an AN6 bolt.