Tiger28760
Member
Finally getting around to buttoning up the fast-build wings.
Page 20-04 has basic instructions, but I have one complication: A Gretz Mount for the GAD26 pitot attached (loosely, right now) on the inboard side of the rib, inboard of the outboard access plate. The joggled end of the Gretz backing plate goes inside the spar flange, and I’m concerned I’ll run into a conundrum between getting access to rivet the aft section and enough flex to put the Gretz backing plate inside the spar flange.
Any suggestions would be appreciated!
Page 20-04 has basic instructions, but I have one complication: A Gretz Mount for the GAD26 pitot attached (loosely, right now) on the inboard side of the rib, inboard of the outboard access plate. The joggled end of the Gretz backing plate goes inside the spar flange, and I’m concerned I’ll run into a conundrum between getting access to rivet the aft section and enough flex to put the Gretz backing plate inside the spar flange.
Any suggestions would be appreciated!