longranger
Well Known Member
I was going through all of the forward fuselage skeleton parts today, marking what holes get countersunk and which ones don't. In looking at drawing 28, I noticed that lowest holes adjacent to the spar cutout (six-pointed stars nearest the center of the photo below) get LP4-3 pulled rivets. Checking the instructions, they tell you to pre-rivet the skin to the side plates along the cutout, but explicitly say to NOT rivet these bottom two holes before installing the side skins.
WHAT goes in these two holes that doesn't go in the other 12? I don't see anything anywhere other than the side skin that gets riveted through these holes. Can anyone tell me what goes here?
WHAT goes in these two holes that doesn't go in the other 12? I don't see anything anywhere other than the side skin that gets riveted through these holes. Can anyone tell me what goes here?