Lycosaurus
Well Known Member
My current definition of baffles: jigsaw puzzle without the photos... and all the pieces can mate with each other.
I have a question regarding the supports on the right baffle floor. The inboard support is just an angled piece bolted to the engine. It basically provides vertical support to the floor. Since this part can rotate around the engine bolt, it does not provide adequate support to hold the baffle tight around the bottom of the #1 cylinder. (I have no problem with the top of the cylinder, since the front/back support is being provided by the side baffle)
Is there anything else in this area to provide solid front/back support for that floor, or are we counting on the the gussets and angles that hold this part to the ring gear baffles? Lots of photos on the net, but did not come across the right one yet. A description would be nice, however if you could steer me to a photo regarding this issue, that would be great. Thanks.
Alfio
I have a question regarding the supports on the right baffle floor. The inboard support is just an angled piece bolted to the engine. It basically provides vertical support to the floor. Since this part can rotate around the engine bolt, it does not provide adequate support to hold the baffle tight around the bottom of the #1 cylinder. (I have no problem with the top of the cylinder, since the front/back support is being provided by the side baffle)
Is there anything else in this area to provide solid front/back support for that floor, or are we counting on the the gussets and angles that hold this part to the ring gear baffles? Lots of photos on the net, but did not come across the right one yet. A description would be nice, however if you could steer me to a photo regarding this issue, that would be great. Thanks.
Alfio
Last edited: