Bubblehead
Well Known Member
I am rerouting CHT and EGT wires and noticed the insulation on the CHT wires near the connectors got oil soaked and has left bare wires. Any problem clipping off the connectors, using heat-shrink to insulate the bare wires and applying new connectors?
Also, I need to shorten the wires. Does it matter if I shorten the leads from the CHT bayonet rather than the EIS-4000?
Also, I need to shorten the wires. Does it matter if I shorten the leads from the CHT bayonet rather than the EIS-4000?