tomhanaway
Well Known Member
Didn't want to hijack the other rivet thread.
I was thinking about the recent SB's for elevators. Don't need to do it but was looking at my doubler plates for turnbuckles.
Apparently, (maybe thinking manufactured head against thinner metal)?, I installed the spar doubler plate rivets for the turnbuckles such that only the shop ends of the rivets are exposed after the elevator leading edge was closed up.
Don't need to do it now but would like to be familiar with procedure when faced with this situation.
Thanks,
Tom H.
I was thinking about the recent SB's for elevators. Don't need to do it but was looking at my doubler plates for turnbuckles.
Apparently, (maybe thinking manufactured head against thinner metal)?, I installed the spar doubler plate rivets for the turnbuckles such that only the shop ends of the rivets are exposed after the elevator leading edge was closed up.
Don't need to do it now but would like to be familiar with procedure when faced with this situation.
Thanks,
Tom H.