couldn't find the answer by searching, so:
I'm getting ready to install the reiff hot strip sump heat system on my RV-6A, O-360. Does it matter where you put the two heating plates on the bottom of the sump? The instructions say to put them on flat, smooth spots, but don't have anything to say about how far apart they should be, or where they might be located for best effectiveness.
The throttle/mixture plate dictates some of the placement, but does it matter other then that? For instance, should I try to mount one plate in the small space on the pilot side of the carb?
How/where did you hot strip users mount yours on your -360? Also, how cold can it be and reasonably expect the supplied epoxy (no longer jb weld) to bond ok?
thanks
I'm getting ready to install the reiff hot strip sump heat system on my RV-6A, O-360. Does it matter where you put the two heating plates on the bottom of the sump? The instructions say to put them on flat, smooth spots, but don't have anything to say about how far apart they should be, or where they might be located for best effectiveness.
The throttle/mixture plate dictates some of the placement, but does it matter other then that? For instance, should I try to mount one plate in the small space on the pilot side of the carb?
How/where did you hot strip users mount yours on your -360? Also, how cold can it be and reasonably expect the supplied epoxy (no longer jb weld) to bond ok?
thanks