Dad's RV-10
Well Known Member
I just replaced the legacy G3X with G3X Touch. At the same time, I replaced a stand-alone Dynon D6 with a G5 on the CAN Bus.
I had to do an attituded calibration for the G5 so I followed the installation manual's guidance and recalibrated the GSU-25 attitude followed immediately by the G5's attitude calibration.
The GSU-25 attitude recalibration seemingly dumped the GMU-22 calibration. I wasn't expecting that to happen and didn't see it mentioned in the installation manual.
I assume this is normal?
When I recalibrate the magnetometer, will that dump any other calibrations?
I had to do an attituded calibration for the G5 so I followed the installation manual's guidance and recalibrated the GSU-25 attitude followed immediately by the G5's attitude calibration.
The GSU-25 attitude recalibration seemingly dumped the GMU-22 calibration. I wasn't expecting that to happen and didn't see it mentioned in the installation manual.
I assume this is normal?
When I recalibrate the magnetometer, will that dump any other calibrations?