I have a Ray Allen Trim Servo with a G407F Grip.
The wiring schematic shows two white wires from the servo, plus ground wire, and 12v power wires . However, the G407F grip does not have a provision for 12v to the hat switch.
Here is my current layout:
Servo - Orange/White: connect to +5 V (pin 18 of EMS 220)
Servo - White/Blue: connect to to ground
Servo - White Green: connect to general input (pin 4 of EMS 220)
Servo - White to Grip 407 red wire
Servo - White to Grip 407 green wire
G407F - Black wire to ground
Power ?
Links to wiring diagrams:
http://www.rayallencompany.com/RACmedia/instructionsoldT2andT3.pdf
http://www.rayallencompany.com/RACmedia/instructionsG4.pdf
Your help is appreciated.
The wiring schematic shows two white wires from the servo, plus ground wire, and 12v power wires . However, the G407F grip does not have a provision for 12v to the hat switch.
Here is my current layout:
Servo - Orange/White: connect to +5 V (pin 18 of EMS 220)
Servo - White/Blue: connect to to ground
Servo - White Green: connect to general input (pin 4 of EMS 220)
Servo - White to Grip 407 red wire
Servo - White to Grip 407 green wire
G407F - Black wire to ground
Power ?
Links to wiring diagrams:
http://www.rayallencompany.com/RACmedia/instructionsoldT2andT3.pdf
http://www.rayallencompany.com/RACmedia/instructionsG4.pdf
Your help is appreciated.