[JonJay]

I have resistive fuel senders going into EDM 930. Although I am sure I tested the sendors quite a few years ago, through the EDM 930's fuel set up program I am reading numbers as follows;

empty = 88.3 ohms
1/4 = 76.8
1/2 = 75.8
3/4 = 74.8
Full = 36.4

I am at a loss other than to think, many years ago, I put the senders in the wrong direction or something like that. I dont know what to make of these readings.

Pulling the senders is a job I am not looking forward too with wings on and full fuel tanks. Oh well.

 

[JonJay]

Sorry folks. Unhooked the JPI, drained the tanks, and used a standar ohm meter on the sender. Nothing wrong there, so I will contact JPI and see what i am doing wrong in the set up.