Lemmingman
Well Known Member
Dwg 3, Section E-E calls out the hardware used to attach the VA146 assembly to the rear spar.
The drawing shows 4x washers with the part number AN960-10. I am not able to find that washer in any of the bags, but in the bag that contains the correct nuts (bag 615) I found 6x AN960-416 and 6X AN960-416L. The difference is that one of them (The L according to another post) is thinner than the non-L.
Mr Google says that the -10 is a #10 size and -416 is 1/4". Does anyone remember if they ran across this during they're build? Did you just substitute the -416 for the -10?
The drawing shows 4x washers with the part number AN960-10. I am not able to find that washer in any of the bags, but in the bag that contains the correct nuts (bag 615) I found 6x AN960-416 and 6X AN960-416L. The difference is that one of them (The L according to another post) is thinner than the non-L.
Mr Google says that the -10 is a #10 size and -416 is 1/4". Does anyone remember if they ran across this during they're build? Did you just substitute the -416 for the -10?