Gsuit
Well Known Member
Ok, threads hit all around this issue, but I didn't find any that dealt with it directly; so either I'm an island unto myself, or... well, it's probably something I'm missing once again
I have QB wings and I've built the float senders, somehow dodging all the usual traps of wire bending. They work properly, and "float" the right direction. My problem is I can't figure out how to see inside the tank to know if I'm keeping to the "1/8" maximum" measurement that the plans call for.
Anyone know a trick, or does it even matter with GRT calibration?
I have QB wings and I've built the float senders, somehow dodging all the usual traps of wire bending. They work properly, and "float" the right direction. My problem is I can't figure out how to see inside the tank to know if I'm keeping to the "1/8" maximum" measurement that the plans call for.
Anyone know a trick, or does it even matter with GRT calibration?