Iām planning on replacing the clear plastic tubing that was used for my pitot-static with newer hard plastic tubing and push to connect fittings.
The existing tubing is 1/4ā I.D. And it looks like the push to connect fittings with the 1/8ā NPT connectors use 1/4ā O.D. Hard plastic tubing. I would then splice with a barbed connector to convert to the push to connect.
Is that the correct size of tubing? I think it as but thought I should ask before ordering.
The existing tubing is 1/4ā I.D. And it looks like the push to connect fittings with the 1/8ā NPT connectors use 1/4ā O.D. Hard plastic tubing. I would then splice with a barbed connector to convert to the push to connect.
Is that the correct size of tubing? I think it as but thought I should ask before ordering.