Bob_pipedream
Active Member
Hi all,
Just about to wire in a new intercom PS1000II and was wondering why it is necessary to run a wire to the Mic socket tip? Could I not just use two core shielded wire to the Mic GND/Low and Audio high and leave the tip disconnected and then run the PTT from ground through the switch on the control column and then directly to the intercom PTT pin in?
Thanks all,
Bob
Just about to wire in a new intercom PS1000II and was wondering why it is necessary to run a wire to the Mic socket tip? Could I not just use two core shielded wire to the Mic GND/Low and Audio high and leave the tip disconnected and then run the PTT from ground through the switch on the control column and then directly to the intercom PTT pin in?
Thanks all,
Bob