Does anyone have a good procedure for removing (and installing) cylinder hold down studs on an O-320 case? I have a couple of 3/8th studs that need to be replaced because the threads are badly damaged.
I already sent the case to get overhauled and most damaged studs were replaced but two were missed.
I was thinking of getting one of these collets with the appropriate housing but I am not sure if there is something better out there.
http://www.sears.com/shc/s/p_10153_12605_SPM250268727P
Anton
I already sent the case to get overhauled and most damaged studs were replaced but two were missed.
I was thinking of getting one of these collets with the appropriate housing but I am not sure if there is something better out there.
http://www.sears.com/shc/s/p_10153_12605_SPM250268727P
Anton