Mark Browning
Active Member
Hi everyone
Just wondered if anyone could offer a solution as to why the elevator push rod doesn't seem long enough ?
I hooked up the servo to the elevator trim tab. With the trim set in the neural position and the servo on mid travel the push rod is too short ?
i have to run run the servo motor almost fully out so the clevis pin fits
Any help would be appreciated![Smile :) :)](data:image/gif;base64,R0lGODlhAQABAIAAAAAAAP///yH5BAEAAAAALAAAAAABAAEAAAIBRAA7)
Just wondered if anyone could offer a solution as to why the elevator push rod doesn't seem long enough ?
I hooked up the servo to the elevator trim tab. With the trim set in the neural position and the servo on mid travel the push rod is too short ?
i have to run run the servo motor almost fully out so the clevis pin fits
![elevator2_zpstg16exzt.jpg](/community/proxy.php?image=https%3A%2F%2Foi1024.photobucket.com%2Falbums%2Fy301%2Fmarkbrowning%2Felevator2_zpstg16exzt.jpg&hash=402ab37f9003a18d4e7c6a25d1371230)
![elevator1_zpspkudksbp.jpg](/community/proxy.php?image=https%3A%2F%2Foi1024.photobucket.com%2Falbums%2Fy301%2Fmarkbrowning%2Felevator1_zpspkudksbp.jpg&hash=c8d9687c9ab54a66929e81ce4f698e9a)
Any help would be appreciated
Last edited: