[Charles in SC]

When life permits me another shop session I will be sealing shut the fuel tank access holes where the fuel senders are mounted. I am planning to use pro seal instead of the cork gaskets. My question is do I just tighten the screws to a normal torque? If I do this will I squeeze out to much sealant or will it be ok?
Thanks in advance!

 

[Mel]

Use normal torque!

 

[climberrn]

Will you able to get it apart in the future if the sending unit ever goes bad?

 

[TSwezey]

Normal torgue. Let it dry and check the torgue again. You will be able to get them apart after sealing. I use a sharp razor knife.