aeroaddict
Well Known Member
I'm building the rt wing leading edge assembly and have come across an issue that I do not see on the left wing. I did not build the left wing and it is complete minus bottom skins and control linkages.
Two leading edge ribs outboard of the tie down have two extra holes per rib. The attached pics show the spar (poor picture quality) and one of the ribs in question on top of a 'normal' rib. The spar holes have anodize in them, so it came from the factory this way. The left wing leading edge ribs and spar do not have the extra holes from what I can see.
I researched the plans and b/p's and searched here on VAF without success. I also have a email in to Van's but have yet to hear back after 4 days. I would like to keep building but need an answer or clarification.
[/IMG]
[/IMG]
Two leading edge ribs outboard of the tie down have two extra holes per rib. The attached pics show the spar (poor picture quality) and one of the ribs in question on top of a 'normal' rib. The spar holes have anodize in them, so it came from the factory this way. The left wing leading edge ribs and spar do not have the extra holes from what I can see.
I researched the plans and b/p's and searched here on VAF without success. I also have a email in to Van's but have yet to hear back after 4 days. I would like to keep building but need an answer or clarification.
Last edited: