I cleaned out my HF pneumatic riveter and can't seem to get it setup right. It rivets fine but it seems to flattening the face of the rivet. As though it's pulling the rivet too hard or if the stroke length is too long?
I turned the air down to about 40 psi and tried to loosening the lock nut and adjusting the jaw assembly either forward or back but it doesn't really seem to make any difference.
Does this sound like the stroke length if so how do I shorten it?
Robert
I turned the air down to about 40 psi and tried to loosening the lock nut and adjusting the jaw assembly either forward or back but it doesn't really seem to make any difference.
Does this sound like the stroke length if so how do I shorten it?
Robert
Last edited: