SeanB
Well Known Member
I recently read a Kitplanes article describing the installation of Fiberfrax and foil for the lower engine cowl. I am getting ready to do this myself, so studying now. It is suggested to use Pliobond contact cement to attach the Fiberfrax to the fiberglass cowl, then aluminum foil over both. I understand the whole process, but am not sure how much Pliobond should be applied for the Fiberfrax. Just along the edges so it stays in place enough until the foil is applied? Or, apply it to the entire area of Fiberfrax?
Thanks!
Thanks!