hydroguy2
Well Known Member
I'm working on the baffle/plenum install. It is obvious to align the FWD inlets of the plenum to the inlet rings of my James cowl. But:
1. what about the aft end of the plenum?
2. Is it best to keep it as low as possible? or maximize the volume?
3. What about clearance to the cowl?
I've seen a few pics and read a few build logs, but wondering if there is a preferred methood.
1. what about the aft end of the plenum?
2. Is it best to keep it as low as possible? or maximize the volume?
3. What about clearance to the cowl?
I've seen a few pics and read a few build logs, but wondering if there is a preferred methood.
