Jamie Aust
Well Known Member
Hello All,
I have been working on this for some time now, I would like to get feedback to see if this will be ok. I hope to NOT get any blue smoke !
What I used.
windows Paint
windows Picture fax viewer ( to rotate only )
My setup. Very basic day VFR.
0-360 fixed pitch carb ( no F/I or electric ig )
acs a-510 key ignition
60 amp ANL fuse and Dynon shunt on firewall.
No avionics master. My check list has them turned off before start/shutdown.
From other electrical systems I have seen , they all tend to use switches instead of a keyed ignition, so this is to help myself and others that might need a clear way to wire it up.
I have not put any devices in as yet, onto the main bus for two reasons.
1) I wanted a clean template. ( so others can used this template if suitable )
2) its easy to edit them in latter.
Item that will be going on the main buss are:
Efis - skyview 10"
Comm - Icom A200
Txpdr - Gtx327
Flap
Boost pump
Intercom - Spa400
lights - strobe/Nav.
The large ( Fat wires ) I have dont seem to be very flexible, has anyone used welding wire or 4x4 battery wire , both are very flexible.
That is the best I can do with the picture, my original file is a 5meg Bmp file, can anyone help with hosting that file size/format ?
I have been working on this for some time now, I would like to get feedback to see if this will be ok. I hope to NOT get any blue smoke !
What I used.
windows Paint
windows Picture fax viewer ( to rotate only )
My setup. Very basic day VFR.
0-360 fixed pitch carb ( no F/I or electric ig )
acs a-510 key ignition
60 amp ANL fuse and Dynon shunt on firewall.
No avionics master. My check list has them turned off before start/shutdown.
From other electrical systems I have seen , they all tend to use switches instead of a keyed ignition, so this is to help myself and others that might need a clear way to wire it up.
I have not put any devices in as yet, onto the main bus for two reasons.
1) I wanted a clean template. ( so others can used this template if suitable )
2) its easy to edit them in latter.
Item that will be going on the main buss are:
Efis - skyview 10"
Comm - Icom A200
Txpdr - Gtx327
Flap
Boost pump
Intercom - Spa400
lights - strobe/Nav.
The large ( Fat wires ) I have dont seem to be very flexible, has anyone used welding wire or 4x4 battery wire , both are very flexible.
That is the best I can do with the picture, my original file is a 5meg Bmp file, can anyone help with hosting that file size/format ?
Last edited: