Hello all, wanted to get opinions if my Dynon heated pitot install looks good before I carry on. I wanted to get this done before riveting the outer lower skins. Wiring isn't done yet but that's just a matter of installing a connector on the 3 power wires. I was going to use a molex connector for that but I don't have one. I do have molex pins though. Is it OK to use the pins without the plastic connector part and use heat shrink tube over each wire to hold the pins and wires together? I thought I read that on VAF somewhere. It's not like I'm going to take that connection apart frequently.
[/IMG]
[/IMG]