S SteveL Active Member Jun 18, 2019 #1 I'm not really happy with the pitot/aoa tube routing through the spar. Looks like too sharp of a bend and even worse if I were to use the snap bushing. What have others done in this area? Thanks,Steve
I'm not really happy with the pitot/aoa tube routing through the spar. Looks like too sharp of a bend and even worse if I were to use the snap bushing. What have others done in this area? Thanks,Steve
rvator51 Well Known Member Jun 18, 2019 #2 A thought is you could use a 90 degree safe air connector if you think the bend is too sharp. http://www.cleavelandtool.com/Plumbing-Kit-Steam-Gauge/productinfo/SA-A3/ Last edited: Jun 18, 2019
A thought is you could use a 90 degree safe air connector if you think the bend is too sharp. http://www.cleavelandtool.com/Plumbing-Kit-Steam-Gauge/productinfo/SA-A3/