UnPossible
Well Known Member
Hey - I'd like to get my pitot and AOA lines run to the back of the plane where the Dynon AHRS will be located. However, I am not sure of the best way to get them back there.
My plan is as horribly illustrated below. Once they come in from the wing to jog over to the second bay in the seating area (to avoid any possible interacton with the flap linkages) and then to drill a couple of holes above the rear spar to get them below the floor in the baggage area.
Any reason why this will not work? Or is there a better way to get them back there?
Thanks,
Jason
(Jog into the second bay)
(Black circles represent hole locations)
(Dynon AHRS mount)
My plan is as horribly illustrated below. Once they come in from the wing to jog over to the second bay in the seating area (to avoid any possible interacton with the flap linkages) and then to drill a couple of holes above the rear spar to get them below the floor in the baggage area.
Any reason why this will not work? Or is there a better way to get them back there?
Thanks,
Jason
(Jog into the second bay)
(Black circles represent hole locations)
(Dynon AHRS mount)