After rolling the leading edge, and using the edge forming tool, I couldn't quite find the right way to match drill the front and back rolled edges.
It seemed ok when clecoed, but of course, it got this pillowy look after pull-riveting.
I'm looking for some tips on the best way to get these smooth. I saw an RV 7 at the airport that had a very nice rudder and it looked like the bend had a lip on the inside, so it was curved and then kinda clamped at 90degrees perpendicular to the bend. Is anyone familiar with that technique?
Thanks!
It seemed ok when clecoed, but of course, it got this pillowy look after pull-riveting.
I'm looking for some tips on the best way to get these smooth. I saw an RV 7 at the airport that had a very nice rudder and it looked like the bend had a lip on the inside, so it was curved and then kinda clamped at 90degrees perpendicular to the bend. Is anyone familiar with that technique?
Thanks!