dave4754
Well Known Member
Well after 9 years of building i finally starting to paint then will move parts to airport in Dec.
I am using a two part polyurethane paint over an AksoNobel primer. I am using a Devilbiss gun moderate price range(400 Cdn.) and a 60 Gallon 3 HP compressor. I also thinned about 15 %, the Paint is made by Besa very much like Imron or Endura.
The disappointing part is the paint went to a matte finish and not the glossy one I wanted, no runs.... but no gloss.
Any ideas on what i did wrong?
Dave
p.s. i searched the forum but if there are conversations on this please point me to them.
I am using a two part polyurethane paint over an AksoNobel primer. I am using a Devilbiss gun moderate price range(400 Cdn.) and a 60 Gallon 3 HP compressor. I also thinned about 15 %, the Paint is made by Besa very much like Imron or Endura.
The disappointing part is the paint went to a matte finish and not the glossy one I wanted, no runs.... but no gloss.
Any ideas on what i did wrong?
Dave
p.s. i searched the forum but if there are conversations on this please point me to them.