I have two questions on this page.
First, figure 2 shows, on the empennage fairing to vertical stabilizer skin line, "BLIND-DRILL #40, FINAL-DRILL #27 7 PLACES/SIDE." I only count 5 places per side, both on my plane and in the diagram. Are there 2 holes hiding from me?
Second, step 3 says to blind-drill #27 the holes "around the front of the fairing." Figure 1 only shows the middle 1 and the top 1 on each side. I am assuming that I want to continue around and do the bottom 2 holes on each side (pictured but not called out in figure 2). Has anyone done that and regretted it?
First, figure 2 shows, on the empennage fairing to vertical stabilizer skin line, "BLIND-DRILL #40, FINAL-DRILL #27 7 PLACES/SIDE." I only count 5 places per side, both on my plane and in the diagram. Are there 2 holes hiding from me?
Second, step 3 says to blind-drill #27 the holes "around the front of the fairing." Figure 1 only shows the middle 1 and the top 1 on each side. I am assuming that I want to continue around and do the bottom 2 holes on each side (pictured but not called out in figure 2). Has anyone done that and regretted it?