The elevators are the last two pieces, other than the tips, left to construct in my tail kit. I was wondering if the current kit elevator skins are match drilled along both upper and lower trailing edges and if the AEX wedge is also match drilled like they are for the rudder.
My older (12 years) tail kit has only one side of the trailing edge pre-punched with instructions to clamp the wedge between the upper and lower edge together and match drill through the wedge and the other side of the skin.
I'll do whatever is necessary, of course, but if the newer kits are pre-drilled, I would consider ordering new skins and wedges.
Thanks for your replies.
My older (12 years) tail kit has only one side of the trailing edge pre-punched with instructions to clamp the wedge between the upper and lower edge together and match drill through the wedge and the other side of the skin.
I'll do whatever is necessary, of course, but if the newer kits are pre-drilled, I would consider ordering new skins and wedges.
Thanks for your replies.