tdragger1966
Member
Hey folks, new guy here so this is probably a dumb question..
I just bought an almost complete RV-10 tail from another builder and was excited to work on the few remaining tasks. Decided to start by fabricating the trim servo linkage and immediately discovered the hardware that came with the kit had but a single AN470AD4-7 rivet left. I have plenty of 4-8 rivets. Assuming I set the rivet correctly is there any problem using the slightly longer one? Would hate to hit a wall waiting for a single rivet to ship.
Thanks in advance!
I just bought an almost complete RV-10 tail from another builder and was excited to work on the few remaining tasks. Decided to start by fabricating the trim servo linkage and immediately discovered the hardware that came with the kit had but a single AN470AD4-7 rivet left. I have plenty of 4-8 rivets. Assuming I set the rivet correctly is there any problem using the slightly longer one? Would hate to hit a wall waiting for a single rivet to ship.
Thanks in advance!