Gary's RV7A
Active Member
Ok, I understand aluminum fittings on oil coolers are bad...
My question, is there a shorter length fitting (steel) that I can use on my oil cooler so I have clearance from the lower cowling. I have to use a higher capacity (clone 8432) oil cooler because I installed a IO-375. See picture below:
[/IMG]
My question, is there a shorter length fitting (steel) that I can use on my oil cooler so I have clearance from the lower cowling. I have to use a higher capacity (clone 8432) oil cooler because I installed a IO-375. See picture below:
Last edited: