[Peterk]

I'm guessing I already know the answer but its on the drawing so I'll ask...and today is Sunday so Van's and Matco are both closed till Tues. The nose wheel assembly on 35-02 shows washers. It came put together without and the insets for the nut and screw head will not take anything but a 960 which is too small a hole. So I'm planning on putting it back like I found it. Thats my story and I'm stickin to it. We all did the same thing....right?

 

[LIMA HOTEL]

NO WASHERS

That's what I did. I figured if MATCO didn't supply them they really were not needed. The bolts were the correct length without washers (they weren't too long).
Larry

 

[Gagarin737]

Torque value

What torque values must be used for the nuts/bolts used to bolt together the wheel halves? (and where did you find the info?)

Thanks, Joeri.

 

[Tony_T]

Matco Technical Service Bulletin...

What torque values must be used for the nuts/bolts used to bolt together the wheel halves? (and where did you find the info?)

Thanks, Joeri.

...should have been included with your wheel parts. The torque for the wheel halves is 100 in-lbs.
Or, here is a link to the manual, see page 18 for torque values.
http://matco.veracart.com/pdf/MHE51BMANUALp.pdf?Iit=2396&Ict=23

Tony

 

[Gagarin737]

I'm just a lazy guy
Thanks Tony!