miyu1975
Well Known Member
I bought a 4 inch no hole yoke for those tight places like the trailing edges to sqz rivets. My problem is the base of the yoke is thicker than the regular yoke that came with my p.sqzr, thus the pin (normal pin, not adjustable) is too short to make a full sqz. I looked on avery's site to see if they had a longer pin but did not see one. Anyone have a suggestion.? I do have an adjustable pin but I think I messed it some time ago using not enough gap width (that's another story). The reason I think that is because when I use the adj pin it always gets stuck in the mist of the sqz, so I gave up on it ever since that gap episode. as usual thanks all for the advice. My tail is almost done so my dumb questions should cease until about March when my wings arrive.
