Well, I've taken the first step on the long road. This is my first time riveting, and thought I'd seek the input of the group here.
I've started the Van's toolbox project and was having a few riveting issues on the hinge. I've used the squeezer on them and while most of them are good, there are a few where the shop head is overly flat. I felt like I was using the same force on the squeezers.
Any suggestions for more consistent rivets? How about to keep arms and hands from falling off after squeezing way more rivets than on the toolbox?
Thanks.
Allen
I've started the Van's toolbox project and was having a few riveting issues on the hinge. I've used the squeezer on them and while most of them are good, there are a few where the shop head is overly flat. I felt like I was using the same force on the squeezers.
Any suggestions for more consistent rivets? How about to keep arms and hands from falling off after squeezing way more rivets than on the toolbox?
Thanks.
Allen