Jconard
Well Known Member
So, I first installed my oil cooler on the baffling in accordance with Vans diagrams. But I have decided to use a few different fittings to make it work a bit better.
When I removed the npt-an fittings, the threads of one were badly galled. I used EZ Turn, when I installed, and I am pretty sure I did not over tighten them, but I do not want to buy another cooler, unless I have to.
Any ideas on a place to have the threads repaired?
When I removed the npt-an fittings, the threads of one were badly galled. I used EZ Turn, when I installed, and I am pretty sure I did not over tighten them, but I do not want to buy another cooler, unless I have to.
Any ideas on a place to have the threads repaired?
