I have purchased a Trio EZ Pilot removed from an update and have the adapter pigtail that I got from Trio to replace my Navaid autopilot. I have read volumes about how easy the conversion is to do. However, when I was removing my Navaid this morning, the connector removed easily but there is a separate red and white wire adjacent to the connector. I stood on my head in my RV-8 and traced it to a large wire bundle where it has a flat yellow connector then back to the bundle. I couldn't tell where it went after that and didn't want to take the bundle apart until I had asked for some expert advice.
I was able to get it all back together (and it worked....) but am not sure what to do about this separate two wires that I cannot find in any of the Navaid or Trio literature.
It has a 430W and a Porcine selector that I wonder if this could be a part of. However, it seems odd that the wires are not part of the original bundle. I recently purchased the plane and the original builder is not medically able to answer questions.
Thanks for any help that anyone may have!
John
RV-8
I was able to get it all back together (and it worked....) but am not sure what to do about this separate two wires that I cannot find in any of the Navaid or Trio literature.
It has a 430W and a Porcine selector that I wonder if this could be a part of. However, it seems odd that the wires are not part of the original bundle. I recently purchased the plane and the original builder is not medically able to answer questions.
Thanks for any help that anyone may have!
John
RV-8