Hello folks
I am running a shield wire for my Strobe/Nav Aero LEDs in the wings of my RV7A all the way to the VPX and switches. However, I would like to install a molex connector close to fuselage to unplug if i need to remove the wing. Aero install documents instructs to connect shield to ground at a one point. Where do I do that now that i have a molex connector in the middle ?
Also in the diagram attached, why do they show the shield attaching to ground at two points? i thought we are only supposed to connect shield to ground at 1 point only.
![aeroled nav strobe.JPG aeroled nav strobe.JPG](https://vansairforce.net/data/attachments/3/3428-4ed28f04c08af845b04831f3c7be52e5.jpg)
I am running a shield wire for my Strobe/Nav Aero LEDs in the wings of my RV7A all the way to the VPX and switches. However, I would like to install a molex connector close to fuselage to unplug if i need to remove the wing. Aero install documents instructs to connect shield to ground at a one point. Where do I do that now that i have a molex connector in the middle ?
Also in the diagram attached, why do they show the shield attaching to ground at two points? i thought we are only supposed to connect shield to ground at 1 point only.
![aeroled nav strobe.JPG aeroled nav strobe.JPG](https://vansairforce.net/data/attachments/3/3428-4ed28f04c08af845b04831f3c7be52e5.jpg)