GLPalinkas
Well Known Member
I have searched hi/lo to find an answer to this question.
VHF Radio power connection - I remember reading somewhere (probably lectric Bob) that one should supply multiple power wires to the connector as the King radio installation manual shows (4 different pins on the main connector). Question is do I really have to run 4 wires from the buss to the connector or can I loop off the back of one wire run to other pins. I think maybe 2 wires with loops to 2 other pins would be prudent but want to get it right. Also, if looping to other pins is recommended how the heck do you put two wires into one Molex connector pin?
My last aircraft wiring job was in the 60's (F-4's) and just a FEW things have changed.....LOL
VHF Radio power connection - I remember reading somewhere (probably lectric Bob) that one should supply multiple power wires to the connector as the King radio installation manual shows (4 different pins on the main connector). Question is do I really have to run 4 wires from the buss to the connector or can I loop off the back of one wire run to other pins. I think maybe 2 wires with loops to 2 other pins would be prudent but want to get it right. Also, if looping to other pins is recommended how the heck do you put two wires into one Molex connector pin?
My last aircraft wiring job was in the 60's (F-4's) and just a FEW things have changed.....LOL