Hello RV12ers:
I am currently installing the Skyview Update which involves running quite a few new wires thru the tunnel wiring harness (quite a bit of "cuss'in" in the hangar the last few days!).
Has anyone noticed that the AN4 bolt the goes thru the mixer bellcrank comes very close to hitting the wires and brake lines under it?
Has anyone come up with a solution for this?
Regards,
Bob
I am currently installing the Skyview Update which involves running quite a few new wires thru the tunnel wiring harness (quite a bit of "cuss'in" in the hangar the last few days!).
Has anyone noticed that the AN4 bolt the goes thru the mixer bellcrank comes very close to hitting the wires and brake lines under it?
Has anyone come up with a solution for this?Regards,
Bob
