Does anyone know the specifications for min/max toe-in for the -7A main gear?
I looked and could not find this in the plans nor in the builder's manual. I know the topic of toe-in has also come up on the forum before, but in searching here too I couldn't find a definitive specification.
I plan to call Van's on Tue to find out straight from the source. But I don't want to hold up progress for the remainder of the long weekend, so I figured I'd ask here in the mean time. Someone must have asked Van's that same question in the past.
Thanks!
-Roee
P.S. FYI- I measured 1.3 degrees toe-in on the left main, 0.0 on the right. Hoping this is within acceptable tolerances, but if not, I'd prefer to find out ASAP since I'm now working on the fairings.
I looked and could not find this in the plans nor in the builder's manual. I know the topic of toe-in has also come up on the forum before, but in searching here too I couldn't find a definitive specification.
I plan to call Van's on Tue to find out straight from the source. But I don't want to hold up progress for the remainder of the long weekend, so I figured I'd ask here in the mean time. Someone must have asked Van's that same question in the past.
Thanks!
-Roee
P.S. FYI- I measured 1.3 degrees toe-in on the left main, 0.0 on the right. Hoping this is within acceptable tolerances, but if not, I'd prefer to find out ASAP since I'm now working on the fairings.