Well I am finally getting around to crimping the trim motor wires to the Molex micro-fit d-sub pins that are part of the new improved trim motor tray/connectors. I found this reference on crimping d-sub pins:
http://www.classictechnology.ca/PDF/crimpers.pdf
I called the Ray Allen Co. and they stated that the five wires from the trim motor are 26 gauge and that they can be doubled over and crimped as 24 gauge.
I called Molex and they make a custom hand crimper available from Mouser for only $296.26! If you have lots of money lying around the part # is Molex 638190000.
So I ordered the Waldon WHT1921 hand crimper from Avery Tools at $16.95. Hope it works.
Have fun,
Jeff
Edit. Here is an Aeroelectric Tutorial and the SAT 018 tool as suggested by Stein.
http://www.pinrepair.com/connect/#good
http://www.steinair.com/storedetail.cfm?productid=292
http://www.classictechnology.ca/PDF/crimpers.pdf
I called the Ray Allen Co. and they stated that the five wires from the trim motor are 26 gauge and that they can be doubled over and crimped as 24 gauge.
I called Molex and they make a custom hand crimper available from Mouser for only $296.26! If you have lots of money lying around the part # is Molex 638190000.
So I ordered the Waldon WHT1921 hand crimper from Avery Tools at $16.95. Hope it works.
Have fun,
Jeff
Edit. Here is an Aeroelectric Tutorial and the SAT 018 tool as suggested by Stein.
http://www.pinrepair.com/connect/#good
http://www.steinair.com/storedetail.cfm?productid=292
Last edited: