I got a utility lamp to close to the canopy. This caused the canopy to melt causing a concave in the canopy.
I tried pushing the canopy back up after heating it to 200 degrees.the concave got worst.
I turned the canopy upside down, heated up the Plexiglas from the inside of the canopy and was able to remove some of the disfigurement.
I then turned the canopy over, placed utility lamp on the outside of the canopy, heated up to 225 degrees and placed a mold on the inside of the canopy and place 60 pounds of mold and left over night. This got more of the concave out, I still have about a 1/8 inch concave.
In all this stretching and melting I created two nipples on the outside of the Plexiglas about the size of a human nipple. I added heat to 250 degrees to outside of canopy pen pointing the area, but they did not go down.
Help
I tried pushing the canopy back up after heating it to 200 degrees.the concave got worst.
I turned the canopy upside down, heated up the Plexiglas from the inside of the canopy and was able to remove some of the disfigurement.
I then turned the canopy over, placed utility lamp on the outside of the canopy, heated up to 225 degrees and placed a mold on the inside of the canopy and place 60 pounds of mold and left over night. This got more of the concave out, I still have about a 1/8 inch concave.
In all this stretching and melting I created two nipples on the outside of the Plexiglas about the size of a human nipple. I added heat to 250 degrees to outside of canopy pen pointing the area, but they did not go down.
Help