I am preparing to make the initial cut the canopy door gutters to prepare them for the mcmaster seal.
Theres quite a bit of information floating around on this process, but one thing I cannot quite determine is how much of the door gutter to leave when making the initial cut. I am not asking about thickness, I am asking about length of the flange. I have seen some sources say 1 to 1 1/8 inch. For reference I plan to use the method of stuffing the seal with flox to form the proper thickness around the gutter.
See: this previous comment.
But since most of the pictures are offline, it is not clear to me if this would be measured from the inside corner of the gutter. Any insights?
Theres quite a bit of information floating around on this process, but one thing I cannot quite determine is how much of the door gutter to leave when making the initial cut. I am not asking about thickness, I am asking about length of the flange. I have seen some sources say 1 to 1 1/8 inch. For reference I plan to use the method of stuffing the seal with flox to form the proper thickness around the gutter.
See: this previous comment.
But since most of the pictures are offline, it is not clear to me if this would be measured from the inside corner of the gutter. Any insights?