I've been staring at this too long and not sure if I'm setting this up correctly.
I used 3/4 angle on the bottoms to line up all the pedals. I wanted my pedals a bit forward from vertical so I clamped a .125" straight bar across the front of the pedals and then clamped that to all 4 pieces. (c-clamps holding that). It's exaggerated in this picture, but it's probably only 5 degrees. That raises the attachment point for the bottom of the main cylinder too low without the proper edge distance.
If I decrease the forward angle so I'm back within tolerances on the left pedal, the right pedal would be forward of the rudder weldment. A) is that correct? B) how do I get all to align since the 2 pedals are different angles?
Does anyone have any pictures showing this?
Thanks!
[/url][/IMG]
I used 3/4 angle on the bottoms to line up all the pedals. I wanted my pedals a bit forward from vertical so I clamped a .125" straight bar across the front of the pedals and then clamped that to all 4 pieces. (c-clamps holding that). It's exaggerated in this picture, but it's probably only 5 degrees. That raises the attachment point for the bottom of the main cylinder too low without the proper edge distance.
If I decrease the forward angle so I'm back within tolerances on the left pedal, the right pedal would be forward of the rudder weldment. A) is that correct? B) how do I get all to align since the 2 pedals are different angles?
Does anyone have any pictures showing this?
Thanks!