I am nearing the end of the fuselage kit, and starting the map box. I found the supplied door part measured EXACTLY per the plans, however it is in the shape of a trapazoid, not a rectangle. When you put a square on one side the "skew" shows 1/8th of an inch off of 90 degrees at the other end.
Did you find that too, and if so did it make any difference? A quick check holding the door up to the opening seems to me to be enough of an error to make the door not cover the opening.
How was yours?
Did you find that too, and if so did it make any difference? A quick check holding the door up to the opening seems to me to be enough of an error to make the door not cover the opening.
How was yours?