[Charles in SC]

My question is about the area where the cable passes the front spar on the horizontal stab. Does it go over it or do I need to put a hole in the spar and if so where. I cannot find anything in my plans about this. When I put it over the spar it has to bend pretty hard. The only thing I can find in the plan is not very detailed (DWG 32) looks like it goes through. I have an -8 cable.
TIA!

 

[Jamie Aust]

My question is about the area where the cable passes the front spar on the horizontal stab. Does it go over it or do I need to put a hole in the spar and if so where.
TIA!

Hi Charles,

Look at DWG 3 left hand side middle , you will see that you need to drill a 5/8 hole in the LEFT hand side.

 

[Charles in SC]

Thanks Jamie, I saw that but it was rotated 180 degrees and had no part numbers on it so it did not register in my feeble old head.